9.2
Armrests and Side Parts
Side part, disassembled
3
7
2
6
11
1 Side part, complete
4 Side panel
7 Wing or Allen screw M5
10 Crossbeam, (part of the seat frame) 11 Clamping lever M8x60
13 Rearview mirror
16 Parking brake
I I n n s s p p e e c c t t i i o o n n
Armrest padding damaged?
Screws of armrest loose?
Side part padding damaged?
Side part covering damaged?
Side part frame damaged?
Side part holder damaged?
Clamping lever damaged?
Mirror damaged?
NOTE:
The steps for disassembly and assembly of the standard joystick box and the parking brake are only
applicable to the respective types of wheelchair.
Complete Dissassembly
Lift seating system (electrically or manually) and lock, if necessary.
Unscrew wing or Allen screws (7) and remove joystick box (17) or parking brake (16) together with the
holding device from the armrest (1).
Remove cap, if necessary, loosen nut (14) and pull the mirror 13) out of the side part frame (2).
Loosen clamping lever (11) and remove side part (1) in upward direction.
Unscrew clamp lever (9) completely and pull side part holder (8) out of the crossbeam (10).
Loosen screws and washers (18) and detach the crossbeam (10) from the seat frame.
Remove side part padding (5) from the side panel (4) (Velcro fastener).
Rebore carefully the compression rivets (12) located on the lower part of the side panel (4) by means
of a twist drill (3,5 to 4 mm) and detach the side panel (4) from the side panel frame (2).
Loosen screws and washers (6) and remove the armrest padding (3) from the side panel frame (2).
Assembly
The assembly is performed in the reverse order.
22
5
12
4
14
12
18
8
2 Side frame
5 Side pads
8 Side part holder
14 Nut M8 with protecting cap
17 Standard joystick box
13
10
18
9
R R e e m m e e d d y y
> Replace armrest padding.
> Tighten screws.
> Replace side part padding.
> Replace side part covering.
> Replace side part frame.
> Replace side part.
> Replace clamping lever.
> Replace mirror.
NOTE:
If necessary, replace the compression rivets (12) with
plastic rivets or tapping screws during the assembly.
Side part, disassembled
17
1
16
2
15
8
3 Armrest pad
6 Hexagonal screw M4x35
9 Clamping lever M8x60
12 2x Bore hole for compression rivets
15 Bore hole for mirror
18 Hexagonal screws M5x20
with washers (not shown) 4x
7