Disassembly joystick box
Detach BUS cable from (4) joystick box (3).
Loosen set screw (23) at joystick box holder (14) and wing screw (10) at joystick box stay bar (9) and detach
joystick box (3).
Loosen four screws (8) completely and remove together with holder (5, 6 or 7) from the joystick box (3).
If required, loosen two screws and detach guard bow (12) from the joystick box (3)
.
Assembly
The assembly is performed in reverse order.
Disassembly joystick box support bar and joystick box receptacle
Detach joystick box (3) as described above.
Loosen set screw (23) at the armrest (1 and 2 respect.) and detach joystick box support bar.
If necessary, remove slide piece (11) by means of a screwdriver.
Only in RECARO seat
Loosen wing screw (10) at armrest (2) and detach joystick box receptacle (13).
Assembly
For the assembly proceed in the reverse order.
Disassembly joystick box holder (swivable)
Detach joystick box (3) as described above.
Loosen set screw (23) at the armrest (1 and 2 respect.) and detach joystick box holder.
Loosen four nuts (22), detach screw (21) and four levers (18, 19 and 20) from the brackets (17).
Loosen two Phillips screws (24) and remove guide pieces (15 and 16) from the brackets (17).
If necessary, remove slide pieces (11) from the guide pieces (15 and 16) by means a screwdriver.
Assembly
The assembly is performed in the reverse order.
NOTE:
When assembling make sure that the lever with the pressure piece (20) is installed in such a way that the
guide piece (16) can lock into place when swivelled.
Disassembly joystick box holder for attendant
Detach joystick box (3) as described above.
Recaro seat:
Standard / Comfort seats
If necessary, remove slide piece (11) by means of a screw driver.
Assembly
The assembly is performed in the reverse order.
Loosen screw at push handle and detach holder (27).
Loosen nuts (30) and detach holder (26) completely
with clamps (28) and screws (29) from the backrest.
93