Installing Vent Tray Onto Wheelchairs Equipped With Foot Tilt Release Pedal - Invacare Solara 3G Service Manual

SECTION 11—VENT TRAY
Installing Vent Tray
NOTE: For this procedure, refer to FIGURE 11.4.
1. With the vent tray positioned on the rear brackets, secure the vent tray to the front bracket with two
screws and locknuts. Tighten securely.
2. Secure the vent tray to the rear brackets with four
5
/ Inch Mounting
8
Screws
Vent Tray

Installing Vent Tray onto Wheelchairs equipped with Foot Tilt Release Pedal

NOTE: Additional Kit #1163914 is required to install vent tray on wheelchairs equipped with Foot Tilt Release Pedal.
NOTE: Additional Kit #1163917 is required to install foot tilt lock out on Solara 3G wheelchairs equipped with vent tray.
Kit #1163914 and 1163917 contain the following:
DESCRIPTION
Vent Foot Tilt Connecting Link
Nylon Washer
1
/ - 28 Locknut
4
Nylon Spacer
1 Inch Mounting Screw
1
2 / Inch Mounting Screw
4
7
/ inch Nylon Washer
8
Foot Tilt Release Pedal
Solara®3G/Spree 3G
5
/ inch mounting screws and locknuts. Tighten securely.
8
FIGURE 11.4 Installing Vent Tray
QTY QTY
#1163914 #1163917
1 N/A
3 N/A
2 N/A
2 N/A
2 N/A
1 N/A
2 1
1 N/A
Locknuts
DESCRIPTION
Coved Spacer
11
/ inch Washer
16
5
/ - 24 Locknut
16
Nylon Washer
Tilt Lockout Release Pedal
2 Inch Mounting Screw
5
/ - 18 Locknut
16
100
1
/ inch mounting
2
Rear
Bracket
Front
Bracket
1
/ inch Mounting
2
Screws
QTY
#1163914
2
1
1 (Nylon)
1
N/A
N/A
N/A
Part No 1160889
QTY
#1163917
1
2
N/A
N/A
1
1
1