Invacare STORM Service Manual page 32

Assembly

NOTE:
• The assembly is performed in the reverse order.
• When assembling, always use new starlock caps (16).
• During the assembly, attention is to be paid to the correct location of the parts (left, right).
• Adjust legrests to equal length.
• Adapt locking screws (24) correctly and secure with nuts (28).
For the assembly of the legrest elbow tube (9) and the legrest upper part (6), proceed as follows:
• Assemble the backlocking unit (39), insert guide rod (13) and screw on nut (12).
• Place backlocking unit (39) with washers (15) on legrest elbow tube (9) and insert the release lever (14).
• Insert starlock cap (16) into starlock tool and position tool correctly over the legrest elbow tube (9) and
the release lever (14).
• Fasten tool at first handtight and afterwards tighten with a ring spanner until cap (16) is completely pressed
on.
• Loosen starlock tool and remove.
• Insert the upper end of the guide rod (13) into the legrest upper part (6).
• Insert starlock cap (16) into the starlock tool and position tool correctly over the legrest upper part (6) and the
guide rod (13).
• Fasten tool at first handtight and afterwards tighten with a ring spanner until the cap (16) is completely
pressed on.
• Loosen starlock tool and remove.
• Assemble bushing (10), legrest elbow tube (9) and legrest upper part (6) and screw together with the screw
(11) and the nut (12).
• The remaining assembly steps for the completion of the legrest are performed in reverse order of the disas-
sembly.
Starlock tool with caps
32
Insertion of the caps
16