Disassembly (complete)
Remove connection plug (42) from the socket (in front, at lower part of battery holder).
Remove caps (31) from screws (30).
Loosen screws (30) at legrest upper part (6) and at legrest elbow tube (14) and detach the actuator (27)
with bushings (28) and washers (29) completely.
Release legrest locking (5) and lift legrest off the hinge bolts (3 and 4).
Loosen wing screw (25) and pull the insert tube (32) with footplate tube (33) and footplate (34) from the
legrest elbow tube (14).
Loosen screw (36) with washers (37) and nut (38) completely and separate insert tube (32) from foot-
plate tube (33).
If required, loosen locking screw (35) and nut (39) and detach from footplate tube (33).
Loosen tapping screws (40) completely and detach footplate (34) from footplate tube (33).
Loosen Phillips screws (19) completely and, together with nuts (20), detach from clamping piece (15).
Detach clamping piece (15) completely with calfplate (18) from the legrest elbow tube (14).
Loosen two Phillips screws (24) and separate calfplate holder (17) from calfplate (18).
Remove cap (26), loosen nut (23) and detach together with washer (22).
Detach calfplate holder (17) from the calfplate rocker (16).
Remove dowel pin (21) and detach calfplate rocker (16) from clamping piece (15).
Loosen Phillips screw (12) and nut (13) completely and detach legrest elbow tube (14) with washers (8)
from joint plates (9 and 10).
Loosen two screws (11) and nuts (13) completely and detach joint plates (9 and 10) from legrest upper
part (6).
If necessary, remove slide pieces (7 and 41).
NOTE:
The slide pieces are inserted. They can be lifted up with a suitable tool,
such as a screwdriver.
Assembly
The assembly is performed in the reverse order.
34