Invacare STORM Service Manual page 98

Disassembly Joystick Box
• Detach BUS cable (22) from the joystick box (1).
• Loosen screw (38), open clamp (37,) and detach joystick box (1) from the receiving tube (5).
Assembly
• The assembly is performed in the reverse order.
Disassembly Actuator
• Detach actuator connection cable (40) from the wheelchair and put aside.
• Remove caps (21), loosen nuts (13) completely and detach together with washers (12).
• Support actuator (29), remove screws (11) and detach actuator from the backrest holder (2) and from the
swivel arm (3).
Assembly
• The assembly is performed in the reverse order.
Disassembly Switch Box
• Detach connection cable (40) from the wheelchair and put aside.
• Loosen nut (27) completely and detach together with screw (26).
• Detach switch box (28) from the switch box rod (23).
• If required, loosen the wing screw (7) and detach the switch box rod (23).
Assembly
• The assembly is performed in reverse order.
Disassembly Holder, complete
• Detach joystick box (1) as described above.
• Remove actuator (29) and guide rod (4) as described above.
• If required, remove switch box (28) and switch box rod (23) as described above.
• Loosen clamping lever (20) and remove together with screw (19) and washer (12) from the receiving tube (5).
• Detach receiving tube (5) with clamps (18) carefully from the swivel arm (3) while uncovering the BUS cable (22).
• Remove BUS cable (22) completely from the swivel arm (3) and detach from the wheelchair.
• Remove cap (17), loosen nut (16) and detach swivel arm (3) with bushing (14) and washers (15) from the
backrest holder (2).
• Loosen wing screws (7) or clamping lever (20), respectively, and detach backrest holder (2) from the holding
devices (31 or 34 respectively).
Recaro seat:
Standard / Comfort seat:
• If necessary, remove slide pieces (9 and 10 respectively).
Assembly
• The assembly is performed in reverse order.
98

NOTE:
• The guide rod (4) is to be dismounted in a similar
way.
• The guide piece (6) can also be removed from the
guide rod (7) after loosening the wing nut.
• Do not forget the bushing (8) when assembling.
• Loosen 4 nuts (27) and detach together with washers (33).
• Remove screws (32) and detach holding device (31) from the seat.
• Loosen Phillips screws (35) and detach holding device (34) together with
rosettes (36) from the backrest.