Invacare STORM Service Manual page 74


NOTE:
• The following two steps apply only to motors with a
coupling mechanism.
• Lock the motor by turning the shaft left by means of a suitable tool
(e.g., a pipe wrench) = driving position.
• Now mount the disengaging lever and fasten it by tightening
the locking screw (SW 8 mm).
The locking screw (M 5 x 10) must contact exactly the flattened
part of the shaft (see drawing).

NOTE:
Following the assembly, make sure that no moving parts such
as rods or screw connections are sliding against the motor
casing. Conduct a performance test.
• Lead the motor cable to the main module
and plug the connection plug into the
socket board.
• Secure the cables by means of cable binders
• Mount the splash protection.
CAUTION:
Following the assembly, the correct operating of the
disengaging lever as well as the driving functions must be tested.
74
Connection Plan: Motor Plug
linker Fahrmotor
left driving motor
M 2
>Make a test drive!<
Position of Disengaging Lever
Disengaging
Locking Screw
Lever
M5 x 10 - SW 8 mm
Batterie
ACS-Fahrpult
Battery
ACS-Remote
– – + +
1 D
+
X
B
U
S
24V
zu weiteren Modulen
Position of the Cable Binders
rechter Fahrmotor
right driving motor
M 1
2
Cable
Binders