Invacare STORM Service Manual page 49

Disassembly, seat recline adjustment complete
• Only for electrical legrest adjustment:
• Release legrest lock and detach legrests.
• Release quick-release bolt (29) at the upper part of the seat recline adjustment device (not shown) or at
actuator (21), and remove, if appropriate, together with washers.
• Only for actuator:
• Loosen nut (24) completely and remove together with washer(25) from the screw (23).
• Support actuator (21) or seat recline adjustment with your hand, remove screw (23) together with
washer (25) and detach actuator (21) or seat recline adjustment device from the seat frame (13).
• Only for actuator:
• Only for manual adjustment:
Assembly
• The assembly is performed in reverse order.
Disassembly, Seat Module and Seat Frame complete
• If necessary, remove headrest. See chapter 10.2 in this respect.
• Detach joystick box and, if existing, brake lever from the side parts.
• Detach side parts from the seat frame (13). See chapter 10.3 in this respect.
• If necessary, detach the connection cable of the actuators and remove the cable clamps from the
connection cable.
• Release legrest lock and remove legrests.
• Release the quick-release bolt (29) of the seat recline adjustment (not shown) or of the actuator (21) respec-
tively, and place the Recaro seat forward on top of the chassis (33).
• Loosen nut (16) at the upper part of the mounting plate (31) completely and detach together with washers
(15) from the screws (14).
• Support Recaro seat, remove screws (14) with washers (15) and remove the Recaro seat completely from the
chassis (33).
• Place the Recaro seat on its side and remove screws (8) or (11 and 12) completely.
• Separate seat frame (13) from the Recaro seat.
• If necessary, remove clamping lever.
• If necessary, loosen two screws M8x20 with washers (not shown) at lower part of the mounting plate (31)
completely, and detach the mounting plate from the chassis (33).
Assembly
• The assembly is performed in reverse order.
Remove connection plug from the sockets (front, below) at
the battery box retainer.
Remove connection plug from the socket (front, below) an der
at the battery box retainer.
Loosen nut (28) at connecting rod and detach together with
washer (27). Detach screw (26) together with washer (27) and
remove the top of connecting rod (30) from the connecting rod
of the actuator.
Rotate threaded out of the adjustment device. If required,
press bushing out of the threaded rod.
49