Yamaha RX10LTGTYL Service Manual page 863

STEERING
5. Install:
S Tie rods 1
NOTE:
S Make sure that the indentation a on the tie rod
faces out.
S The threads on both rod ends must be the
same length.
CAUTION:
Always use new cotter pins.
Locknut (rod end):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
Nut (tie rod-idler arm):
30 Nm (3.0 mSkg, 22 ftSlb)
Nut (tie rod-steering arm):
35 Nm (3.5 mSkg, 25 ftSlb)
6. Install:
S Steering shaft 1
S Locknuts 2
S Joints 3
Steering
A
shaft part
number
227.8 mm
8FA-23840-00
(8.9685 in)
NOTE:
Make sure that the end of the steering shaft
(white plating side 1 ) is connected to the steer-
ing column.
CAUTION:
Always use new cotter pins.
Nut (steering shaft):
35 Nm (3.5 mSkg, 25 ftSlb)
18
CHAS

Set
B C Shaft
a length b
length
170.0 mm
(6.6929 in)