Using Netware - Ricoh 920F Operating Instructions Manual

3. Using a Printer Server

Using NetWare

This section describes the setting procedure for network printers in the NetWare environment. In the
NetWare environment, you can connect the machine as a "print server" or "remote printer".
• IPv6 can not be used on this function.
Setting procedure
3
• When using the machine as a print server
1. Installing SmartDeviceMonitor for Admin
2. Setting the network interface board.
3. Turning the machine off and then back on.
• When using the machine as a remote printer
1. Installing SmartDeviceMonitor for Admin.
2. Setting the network interface board.
3. Setting NetWare.
4. Starting the print server.
• This procedure assumes an environment is already prepared for normal NetWare running
the printing service setting.
• The procedure is explained with the following example settings:
Using SmartDeviceMonitor for Admin
To use the machine in a NetWare environment, use SmartDeviceMonitor for Admin to set the NetWare
printing environment.
Printers listed by SmartDeviceMonitor for Admin
SmartDeviceMonitor for Admin lists printers connected to the network. If you cannot identify the
machine you want to configure, print configuration page, and then check the machine name.
• The NetWare Client provided by Novell is required to set the printing environment using
SmartDeviceMonitor for Admin under the following environments:
• NDS or Bindery mode in Windows 2000
106
• File server's name ...CAREE
• Print server's name ...PSERV
• Printer's name ...R-PRN
• Queue name ...R-QUEUE