Ricoh 920F Operating Instructions Manual page 1260

Message
"Exceeded max. number of
search results which can be
displayed. Max.: nnn"
(A figure is placed at n.)
" Func. Problems"
"Data will be initialized."
"LDAP server auth. has
failed. Check the settings."
"LDAP server search timed
out. Check the server status."
"Memory is full. Scanning
will be stopped and only
scanned page(s) will be
stored."
"Put original back, check it
and press Start key."
"Sender has not been
specified."
"Settings have been
updated. The selected dest./
functions have been
cancelled."
Cause
The number of search results
has exceeded the maximum
number of items that can be
displayed.
There is a problem with the
fax.
The entered user name or
password does not match that
specified for LDAP server
authentication.
A network error has occurred
and connection has failed.
The memory is full.
Original jammed during
Memory Transmission.
The sender has not been
specified.
The destination list is being
updated from the network
using SmartDeviceMonitor for
Admin or Web Image
Monitor.
Messages Displayed When Using the Facsimile Function
Solution
Search again after changing the search
conditions.
Record the code number shown in the
display and contact your service
representative. Other functions can be
used.
Make settings correctly for the user
name and the password for LDAP server
authentication.
Try the operation once more. If the
message is still shown, the network may
be crowded. Check the information of
[System Settings]. See "Administrator
Tools", Network and System Settings
Guide .
If you press [Exit], the machine returns to
standby mode and starts transmitting the
pages that have been stored.
Place originals that have not been
scanned on the exposure glass or ADF
again.
A sender's name should be specified
before sending e-mail. Send e-mail after
specifying the sender's name.
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on the
number of destinations to be updated,
there may be some delay before you
can resume operation. Operations are
not possible while this message is
displayed.
3
43