Checking The Specified Destination - Ricoh 920F Operating Instructions Manual

1. Transmission
• Group destination can be used only for Memory Transmission; it cannot be used for Immediate
Transmission.
• If you specify a group after selecting Immediate Transmission, the mode switches to Memory
1
Transmission.
• If you try to select Immediate Transmission after specifying a group, the "Dest. and functions that
could not be specified on immediate transmission is already selected." message appears. When
this happens, press [Exit].
• The total number of destinations programmed in multiple groups should not exceed the maximum
number of destinations you can specify for one file, see "Maximum Values".
1. Press [
2. Press the Quick Dial key in which the group is programmed.
If you make a mistake, press the [Clear/Stop] key and try again.
To select more destinations, repeat steps 1 and 2.
When you add destinations, if you switch the destination type between
and then repeat steps 1 and 2.
3. Press the [Start] key.
• To view which destinations are registered in a group, print the group list using the Address Book:Print
List function under System Settings. For details about the printing method, see "System Settings",
Network and System Settings Guide.
• A confirmation message appears if the destination group includes an address that is incompatible
with the specified destination type. Press [Select] to specify destinations where the numbers or
addresses of the specified destination type are registered. Press [Cancel] to change the destination.
• To cancel any destination(s) among the group, press [ View] and display the desired destination
using [ ] or [ ], and then press the [Clear/Stop] key.
• p.258 "Maximum Values"

Checking the Specified Destination

This section explains how to check the specified destinations.
60
] to switch the destination type between and .
and , press [Add Dest],