Ip-Fax Settings - Ricoh 920F Operating Instructions Manual

IP-Fax Settings

This section describes the User Tools in the IP-Fax Settings menu under Fax Features.
Default settings are shown in bold type.
Make settings to use IP-Fax.
Set H.323 for the gatekeeper, SIP for SIP server, and the VoIP gateway to G3 fax if necessary. Check the
settings of the network to which this machine is connected before making settings.
The following characters can be used for registration of the alias telephone number in H.323 Setting. Make
sure you enter these characters correctly:
• Numbers
• Symbols ( and )
The following characters can be used for registration of the SIP User Name in SIP Settings. Make sure you
enter these characters correctly:
• Alphanumeric symbols (lower and upper cases)
• Symbols (;?:&= $,-_.!~
Use numbers and periods (".") to enter the correct IP addresses for the gatekeeper, SIP server, and VoIP
gateway. To obtain the correct IP addresses, consult administrator.
Enable H.323
Specify whether or not H.323 is used for IP-Fax transmission.
The default setting is Off.
Enable SIP
Specify whether or not SIP is used for IP-Fax transmission.
The default setting is Off.
H.323 Settings
Set the IPv4 address and alias telephone number of the gatekeeper.
To use the gatekeeper, set the parameter setting (switch 34, bit 0) to "On".
The default parameter setting for switch 34, bit 0 is Off.
1. Select [Fax Features] using [ ] or [ ], and then press the [OK] key.
2. Select [IP-Fax Settings] using [ ] or [ ], and then press the [OK] key.
3. Select [H.323 Settings] using [ ] or [ ], and then press the [OK] key.
4. Select [Gatekeeper Address (Main)] using [ ] or [ ], and then press the [OK] key.
5. Enter the IPv4 address of the gatekeeper, and then press the [OK] key.
6. Select [Own Fax No.] using [ ] or [ ], and then press the [OK] key.
7. Enter Own Fax No. and then press the [OK] key.
'@()%/[])
IP-Fax Settings
6
205