Ricoh 920F Operating Instructions Manual page 641

2. Other Transmission Features
To cancel the setting, select [Off], and then press the [OK] key. The display returns to that of step 3.
5. Enter the time using the number keys and press [AM/PM] to switch between AM and PM.
Then press the [OK] key.
2
When entering numbers smaller than 10, add a zero at the beginning.
If you make a mistake, press the [Clear/Stop] key before pressing the [OK] key, and then try again.
To cancel Send Later, press the [Escape] key. The display returns to that of step 3.
6. Press the [Escape] key.
The standby display appears.
To check the settings, press [TX Mode].
7. Specify a destination, and then press the [Start] key.
• You can specify a time within 24 hours of the current time.
• If the current time shown is not correct, change it using Set Time under System Settings. For details
about the setting, see "System Settings", Network and System Settings Guide.
• You can cancel the transmission setup for Send Later. See "Canceling a Transmission".
• p.93 "Canceling a Transmission"
100