The Leading Edge Of The Image Is Sporadically Misaligned With The Original; Paper Creases; Offset Occurs - Kyocera KM-1650 Service Manual

(12) The leading edge of the image is
sporadically misaligned with the
original.
Causes
1. Paper feed clutch, bypass paper feed
solenoid or registration motor installed or
operating incorrectly.

(13) Paper creases.

Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Dirty separation electrode.

(14) Offset occurs.

Causes
1. Defective cleaning blade.
2. Defective fixing section.
Causes
1. Paper feed clutch, bypass paper feed solenoid or registration motor installed
or operating incorrectly.
Check procedures/corrective measures
Check the installation position and operation of the paper feed clutch,
bypass paper feed solenoid and registration motor. If any of them oper-
ates incorrectly, replace it.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Dirty separation electrode.
Check procedures/corrective measures
Check the paper storage conditions.
Check the paper storage conditions.
Replace the pressure springs.
Check the drum separation claws and heat roller separation claws.
Clean the separation electrode.
Causes
1. Defective cleaning blade.
2. Defective fixing section.
Check procedures/corrective measures
Replace the drum unit (see page 1-6-38).
Check the heat roller and press roller.
2DA/2DB
1-5-31