Kyocera KM-1650 Service Manual page 90

Maintenance
item No.
Turning the DP scanning position adjust mode on/off
U087
Description
Turns on or off the DP scanning position adjust mode, in which the DP original scanning position is adjusted
automatically by determining the presence or absence of dust on the slit glass. Also changes the reference
data for identifying dust.
Reference
In the DP original scanning position adjust mode, the presence or absence of dust is determined by compar-
ing the scan data of the original trailing edge and that taken after the original is conveyed past the DP original
scanning position. If dust is identified, the DP original scanning position is adjusted for the following originals.
Purpose
Used to prevent appearance of black lines due to dust adhering in the original scanning position on the slit
glass when the DP is used.
Setting
1. Press the start key. The screen for selecting an item is displayed.
2. Select ON or OFF using the up/down cursor keys. The selected item is displayed in reverse.
Display
ON
OFF
Initial setting: ON
Available only when the mode is turned on.
3. Change the setting using the left/right cursor keys.
Description
Minimum density to be regarded as dust
Example
The figure indicates the density in 256 levels of gray (0: white, 255: black). When the setting is 35, data
of the level of 35 or higher is regarded as dust and data of lower level is regarded as the background
(scan data taken when there is no original).
4. Press the start key. The value is set.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Description
Description
DP scanning position adjust mode on
DP scanning position adjust mode off
Setting range Initial setting
10 to 95 35
2DA/2DB
1-4-21