Adjusting The Margins For Printing - Kyocera KM-1650 Service Manual

2DA/2DB-1

(10-5) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-37)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in mainte-
nance mode.
Procedure
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the items to be adjusted
using the up/down cursor keys.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" x 17" paper.
Are the margins correct?
Yes
Proceed to
another mode?
Press the stop/clear key to
exit maintenance mode.
1-6-20
U404
(P. 1-4-44)
Start
LEAD: Printer leading edge margin
AC: Printer left/right margins
TRAIL: Printer trailing edge margin
No
Yes
No
End
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the right cursor
key makes the margin wider.
Decreasing the value using the left cursor
key makes the margin narrower.
Setting range (initial setting)
LEAD: 0.0 – +10.0 (3.0)
AC: –3.4 – +10.0 (3.0)
TRAIL: –5.0 – +10.0 (4.0)
Changing the value by 1 moves the
leading edge by 0.1 mm.
Ejection direction
(reference)
Printer leading edge margin
(3 ± 2.5 mm)
Printer
left margin
+1.5
(2.5 mm)
–2.0
Printer trailing edge margin
(3 ± 2.5 mm)
Figure 1-6-35
Printer
right margin
+1.5
(2.5 mm)
–2.0