Kyocera KM-1650 Service Manual page 87

2DA/2DB
Maintenance
item No.
Adjusting the DP center line
U072
Description
Adjusts the scanning start position for the DP original.
Purpose
To be executed if there is a regular error between the centers of the original and the copy image when the
optional DP is used.
Caution
Before making this adjustment, ensure that the following adjustments have been made in maintenance mode.
U034 U067
Method
Press the start key. The screen for setting is displayed.
Setting
1. Select the item to be set using the up/down cursor keys. The selected item is displayed in reverse.
2. Change the setting using the left/right cursor keys.
Display
1 sided
2 sided front
2 sided back
Increasing the setting moves the image to the right, and decreasing it moves the image to the left.
3. Press the start key. The value is set.
Interrupt copy mode
While this maintenance item is being performed, copying from an original can be made in interrupt copy
mode.
1. Press the interrupt key. The machine enters the interrupt copy mode.
2. Set the original and press the strat key.
To return to the screen for setting, press the interrupt key.
Adjustment
1. In interrupt copy mode, make a copy using the DP.
2. Check the copy image and adjust the center line as follows.
For copy example 1, increase the setting.
For copy example 2, decrease the setting.
Completion
Press the stop/clear key at the screen for setting. The screen for selecting a maintenance item No. is dis-
played.
1-4-18
U072
Description
Simplex copy mode
Front face in duplex copy mode
Reverse face in duplex copy mode
Reference
Original
Description
Setting
range
-39 to +39
-39 to +39
-39 to +39
Copy Copy
example 1 example 2
Figure 1-4-3
Initial Change in
setting value per step
0 0.1 mm
0 0.1 mm
0 0.1 mm