Adjusting The Amount Of Slack In The Paper - Kyocera KM-1650 Service Manual

(10-6) Adjusting the amount of slack in the paper

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Enter maintenance mode.
Enter "051" using the numeric keys.
Press the start key.
Select the items to be adjusted
using the up/down cursor keys.
Press the interrupt key.
Press the start key
to make a test copy.
edge of the image missing
or varying randomly (copy
paper Z-folded (copy
Press the stop/clear key to
exit maintenance mode.
Start
Is the leading
example 1)?
No
Is the copy
example 2)?
No
End
Original
PF1: Drawer
BYPASS: Bypass tray
PF2: Optional first paper feeder (standard for 20 ppm model)
PF3: Optional second paper feeder
PF4: Optional third paper feeder
DUPLEX: Duplex copying (second face)
Press the start key.
The new setting is stored.
Yes
Increase the value using the right cuusor key.
Yes
Decrease the value using the left cursor key.
Setting range (Initial setting)
PF1: –50 – +127 (20)
BYPASS: –50 – +127 (0)
PF2: –50 – +127 (0)
PF3: –50 – +127 (–20)
PF4: –50 – +127 (–20)
DUPLEX: –50 – +127 (0)
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
Copy Copy
example 1 example 2
Figure 1-6-36
2DA/2DB-1
1-6-21