Kyocera KM-1650 Service Manual page 34

2DA/2DB
5. Close the DP, fit the fixing fitting from the
rear side of the right hinge, and secure it
with the two bronze TP screws M3 x 06.
6. Connect the cable of the DP to the MFP.
* Be sure to tighten the fixing screws on both
side of the connector.
7. Clean the pasting position for the caution
label with alcohol.
Paste the caution label that corresponds to
the language according to the destination to
the DP.
[Operation check]
1. Prepare an original on which 4 lines are
drawn 15 mm from the edges and the center
line is drawn.
2. Set the original on the DP and make a test
copy to check the copy image.
At this time, set the paper guide for the origi-
nal table and drawer to the paper size to be
used.
3. If the copy image does not match the origi-
nal image, carry out the following adjust-
ments in maintenance mode.
Maintenance mode 070 (sub-scan line
adjustment)
Maintenance mode 071 (leading edge tim-
ing adjustment)
Maintenance mode 072 (center line adjust-
ment)
1-3-10
Fixing fitting
Bronze TP screws M3 x 06
Figure 1-3-13
Caution label
Figure 1-3-14
15mm
15mm
Lines
15mm
Original
Figure 1-3-15
Cable
15mm
Center line
Lines