Kyocera KM-1650 Service Manual page 102

Maintenance
item No.
Setting the presence or absence of a key card or key counter
U204
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
To run this maintenance item if a key card or key counter is installed.
Setting
1. Press the start key. The screen for selecting an item is displayed.
2. Select the optional counter to be installed using the up/down cursor keys. The selected counter is dis-
played in reverse.
Display
OFF
KEY-CARD
KEY-COUNTER
3. Press the start key. The setting is set and the screen for selecting a maintenance item No. is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Checking the operation panel keys
U207
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. COUNT1 is displayed and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bot-
tom, the figure shown on the touch panel increases in increments of 1. When all the keys in that line are
pressed and if there are any LEDs corresponding to the keys in the line on the immediate right, the top
LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the ejection limit of the job separator
U233
Description
When an optional job separator is installed, whether the limit of ejection to the job separator is 50 sheets for
A3/11" x 17" and 100 sheets for other sizes or 100 sheets for all sizes is set.
Purpose
To be set according to user request.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select the item using the up/down cursor keys.
Display
MODE0
MODE1
Initial setting: MODE0
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
Description
None
The key card is installed
The key counter is installed
Description
All size is limited to 100 sheets.
A3/11" x 17" is limited to 50 sheets
2DA/2DB-3.0
1-4-33