Adjusting The Trailing Edge Margin Of Image Printing - Kyocera KM-1650 Service Manual

(10-4) Adjusting the trailing edge margin of image printing

Make the following adjustment if there is a regular error between the trailing edges of the copy image and original.
Procedure
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the "ADJ. MGN REAR"
using the up/down cursor keys.
Press the start key.
Press the interrupt key.
Press the start key
to output a test pattern.
Is the trailing edge
Press the stop/clear key to exit
maintenance mode.
Start
margin correct?
Yes
End
Trailing edge margin
Press the start key
The new setting is stored
For output example, increase
No
the value using the right cursor
key.
Setting range: –4.0 – +10.0
Initial setting: 0.0
Changing the value by 1 moves the
trailing edge by 0.1 mm.
Increasing the setting makes the margin
narrower, and decreasing it makes the
margin wider.
Correct image Output
example
Figure 1-6-34
2DA/2DB
1-6-19