2DA/2DB-1
7. Fit the three holes on the front of the drawer
heater mounting plate to the positioning por-
tion and the fitting portions on the front side
of the machine.
8. Connect the connector of the drawer heater
wire to YC3 on the drawer heater PCB.
Put the drawer heater wire inside the paper
feeder cover by bending.
9. Refit all the removed parts.
1-3-8-2
1-3-10
Positioning portion
Fitting portion
Drawer heater mounting plate
Figure 1-3-9-3
Drawer heater wire
Figure 1-3-9-4
Fitting portion
YC3
Drawer heater PCB