Fitting The Scanner Wires - Kyocera KM-1650 Service Manual

(2-2) Fitting the scanner wires

Caution:
When fitting the wires, be sure to use those specified below.
Machine front: P/N 2C91236 (gray)
Machine rear: P/N 2C91235 (black)
Fitting requires the following tools:
Two frame securing tools (P/N 302C968310)
Two scanner wire stoppers (P/N 3596811)
Procedure
1. Remove the screw and then scanner wire
drum gear at the machine rear side.
2. Remove the stop ring and bushing from the
front of the scanner wire drum shaft.
3. Remove the scanner wire drum shaft from
the scanner unit.
Scanner wire
drum gear
Figure 1-6-45
Scanner wire drum shaft
Figure 1-6-46
2DA/2DB-3.0
Bushing
Stop ring
1-6-25