Image Is Blurred; The Leading Edge Of The Image Is Consistently Misaligned With The Original; The Leading Edge Of The Image Is Sporadically Misaligned With The Original - Kyocera KM-6030 Service Manual

(10) Image is blurred.

Causes
1. Scanner moves erratically.
2. Deformed press roller.
3. Paper conveying section drive problem.
(11) The leading edge of the image is
consistently misaligned with the
original.
Causes
1. Misadjusted leading edge registration.
2. Misadjusted scanner leading edge regis-
tration.
3. Registration motor operating incorrectly.
4. Misadjusted the amount of slack in the
paper.
(12) The leading edge of the image is
sporadically misaligned with the
original.
Causes
1. Registration motor, MP feed motor, paper
feed motor 1, paper feed motor 2, paper
feed motor 3 or paper feed motor 4
installed or operating incorrectly.
Causes
1. Scanner moves erratically.
2. Deformed press roller.
3. Paper conveying section drive problem.
Check procedures/corrective measures
Check if there is any foreign matter on the front and rear scanner rails. If
any, remove it.
Replace the press roller (see page 1-6-72).
Check the gears and belts and, if necessary, grease them.
Causes
1. Misadjusted leading edge registration.
2. Misadjusted scanner leading edge registration.
3. Registration motor operating incorrectly.
4. Misadjusted the amount of slack in the paper.
Check procedures/corrective measures
Readjust the leading edge registration (see page 1-6-25).
Readjust the scanner leading edge registration (see page 1-6-54).
Check the installation of the registration motor. If it operates incorrectly,
replace it.
Run maintenance item U051 to readjust the amount of slack in the paper.
Causes
1. Registration motor, MP feed motor, paper feed motor 1, paper feed motor 2,
paper feed motor 3 or paper feed motor 4 installed or operating incorrectly.
Check procedures/corrective measures
Check the installation position and operation of the registration motor, MP
feed motor, paper feed motor 1, paper feed motor 2, paper feed motor 3
and paper feed motor 4. If any of them operates incorrectly, replace it.
2FB/2FC
1-5-53