Detaching And Refitting The Laser Scanner Unit - Kyocera KM-1650 Service Manual

(4) Detaching and refitting the laser scanner unit

Take the following procedure when the laser scanner unit is to be replaced.
Procedure
1. Remove the original cover or the DP.
2. Remove the upper right cover, contact
glass, upper rear cover, middle left cover,
upper left cover, slit glass and front scanner
cover (see page 1-6-23).
3. Remove the four screws holding the right
cover and then the cover. Remove the
seven screws holding the rear cover and
then the cover.
4. Detach the connector YC8 on the main
PCB. Detach the connectors YC16,
YC17,YC18 and YC19 on the engine PCB.
Right cover
Figure 1-6-54
YC16
YC17
Figure 1-6-55
2DA/2DB
Rear cover
YC8
YC19
YC18
1-6-29