Quick Programming Mode - Omron SYSDRIVE 3G3RV Series User Manual

K K K K

Quick Programming Mode

In Quick Programming Mode, the parameters required for Inverter trial operation can be monitored and set.
Parameters can be changed from the setting displays. Use the Increment, Decrement, and Digit Selection/
RESET Keys to change the frequency. The parameter will be written and the monitor display will be returned
to when the ENTER Key is pressed after changing the setting.
Refer to Chapter 5 Parameters for details on the parameters displayed in Quick Programming Mode.
nExample Operations
Key operations in Quick Programming Mode are shown in the following figure.
Mode Selection Display
MENU
Quick Programming Mode
DRIVE QUICK ADV VERIFY
Fig 3.5 Operations in Quick Programming Mode (Example for the 3G3IV-PJVOP161)
-8
3
Monitor Display
Control method selection
ESC
AUTO
Reference selection
TUNING
ESC
Operation method selection
ESC
Stopping method selection
AO CH1 output gain
ESC
AO CH2 output gain
ESC
Motor protection selection
ESC
Deceleration stall selection
ESC
DRIVE QUICK
ESC
ESC
ESC
ESC
C1-01: Acceleration time 1 d1-01: Frequency reference 1
C1-02: Deceleration time 1 d1-02: Frequency reference 2
C6-01: CT/VT selection d1-03: Frequency reference 3
C6-02: Carrier frequency d1-04: Frequency reference 4
selection d1-17: Jog frequency reference
ESC
ESC
ESC
ESC
ADV VERIFY AUTO
TUNING
Setting Display
E1-01: Input voltage setting
E1-03: V/f pattern selection
E1-04: Max. output frequency
E1-05: Max. voltage
E1-06: Base frequency
E1-09: Min. output frequency
E1-13: Base voltage (VBASE)
E2-01: Motor rated current