Ricoh G133 Service Manual page 82

Tray Heater (Optional Tray)
11. Clamp the other harness [M] of the two-way harness as shown [N] if you do not install
another optional paper feed unit.
Do steps 12 to 14 if you install another optional paper feed unit below G832. If
not, skip to step 15.
12. Remove the tray bar cover [O] (
13. Remove the harness cover bracket [P].
14. Pass the harness from the lower paper feed unit through the hole [Q], and then
connect it to the harness [R].
Make sure that the harness is clamped, with the bind [S] placed at the right
hand side of the clamp [T].
G133
x 1).
1-52 SM