Ricoh G133 Service Manual page 71

punch unit board (
The cables [E] are coiled and attached to the PCB.
6. Attach the slide drive unit [F] to the finisher and connect it to the punch unit (
x 1). Push in the slide drive unit at
7. Make sure that the punch unit moves freely and is not blocked by the screws.
8. Put the side-to-side detection unit [G] in the machine. Make sure that the two pins are
engaged correctly at the front.
9. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
10. Attach the side-to-side detection unit and connect it at the rear (
11. Pull the short connector out of the connector [H] then connect the cable of the finisher
( x 1).
This is the 3-pin connector.
SM
x 2, x 1).
when you attach the screw
1-41
Punch Unit (B702)
x 2,
.
x 2, x 1, x 1).
G133