Ricoh G133 Service Manual page 541

002 RCG IP Address
[NV-RAM Upload]
Uploads the UP and SP mode data (except for counters and the serial
5824
number) from the NVRAM to an SD card. For details, see the "p.5-3 "NVRAM
Data Upload/Download"" in this section.
5824 1 NV-RAM Upload
[NV-RAM Download]
5825
Downloads the UP and SP mode data from an SD card to the NVRAM. For
details, see the "p.5-3 "NVRAM Data Upload/Download"" in this section.
5825 1 NV-RAM Download
5828 [Network Setting]
1284 Compatibility
050
(Centro)
052 ECP (Centro)
065 Job Spooling
SM
this setting, you must turn the machine off
and on.
[0 to 4 / 0 / 1 /step]
Sets the IP address of the RCG (Remote
Communication Gate) destination for call
processing at the remote service center.
# -
# -
*CTL -
Enables or disables 1284 Compatibility.
[0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
Enables or disables ECP Compatibility.
[0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
This SP is activated only when SP5-828-50 is
set to "1".
Enables/disables Job Spooling.
5-219
Service Mode Table
G133