Ricoh G133 Service Manual page 268

SC Table
No. Type
1.
2.
3.
4.
No. Type
Stack feed-out motor error
723 B
1.
2.
3.
4.
No. Type
725 B Finisher exit guide plate motor error
After moving away from the guide plate position sensor, the exit guide is
G133
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Check the connections and cables for the components mentioned
above.
Replace the jogger HP sensor (if the jogger motor works correctly).
Replace the jogger motor (if the jogger motor does not work).
Replace the finisher main board.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Stack feed-out HP sensor does not detect the home position of the
stack feed-out belt 3000ms after the stack feed-out belt has moved
to its home position.
Stack feed-out HP sensor does not turn off 200 ms after the stack
feed-out belt has moved from its home position. The 1st detection
failure issues a jam error, and the 2nd failure issues this SC code.
Defective stack feed-out HP sensor
Overload on the stack feed-out motor
Defective stack feed-out motor
Defective main board
Disconnected or defective harness
Check the connections and cables for the components mentioned
above.
Replace the stack feed-out HP sensor (if the stack feed-out motor
works correctly).
Replace the stack feed-out motor (if the stack feed-out motor does
not work).
Replace the finisher main board.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
4-52 SM