Ricoh G133 Service Manual page 81

4. Remove the two securing brackets [B] (
optional paper tray (
5. Remove the harness cover bracket [D] (
6. Pull out tray 2 from the mainframe.
7. Replace the shoulder screw [E] with the washer screw [F], using the securing bracket
[G] ( x 1).
8. Connect the harness [H] to the connector [I] of the tray heater.
9. Route the harness [H] as shown and clamp it with four clamps (
Make sure that the harness [H] is placed below the harness [J].
10. Connect one harness [K] of the two-way harness to the connector [L] of the mainframe.
Connect [K] to the connector on the mainframe. The harness of connector [K]
has two binders. The harness of the other connector [M] has one binder, and
this is for another optional paper feed unit.
SM
x 1 each), and then the rear cover [C] of the
x 2).
x 1).
1-51
Tray Heater (Optional Tray)
x 4).
G133