Ricoh G133 Service Manual page 278

SC Table
No. Type
1.
2.
3.
When the problem cannot be fixed with the above procedure, the
following information displayed on the screen needs to be fed back to a
technical support center.
CPU/Memory Error
[0702]
[0709]
[070A]
1.
2.
3.
No. Type
CTL Self-diagnostics error: ASIC
821
D [XXXX]: Detailed error code
ASIC error
The write-&-verify check error has occurred in the ASIC.
[0B00]
1.
[0B06] ASIC detection error
The I/O ASIC for system control is not detected.
G133
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Turn the main switch off and on.
Reinstall the controller system firmware.
Replace the controller.
SC code
Detailed error code
Program address
System firmware problem
Defective RAM-DIMM
Defective controller
Reinstall the controller system software.
Replace the RAM-DIMM.
Replace the controller.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Defective ASIC device
Replace the controller.
Defective ASIC
Defective North Bridge and PCI I/F
4-62 SM