Ricoh G133 Service Manual page 351

Rev. 01/2007
Specifies the additional temperature for the target temperature of the plain
paper for the first print mode. This temperature is added for the time specified
with SP1915-002.
Correction Time: Plain:
Reload
002
Specifies the time for adding the correction temperature (SP1915-001) for the
first print mode.
Correction Temp.:
M-Thick: Reload
003
Specifies the additional temperature for the target temperature of the middle
thick paper for the first print mode. This temperature is added for the time
specified with SP1915-004.
Correction Time: M-Thick:
Reload
⇒
004
Specifies the time for adding the correction temperature (SP1915-003) for the
first print mode.
Correction Temp.:
M-Thick: Normal
005
Specifies the additional temperature for the target temperature of the middle
thick paper at recovery from the stand-by mode. This temperature is added for
the time specified with SP1915-006.
Correction Time: M-Thick:
Normal
⇒
006
Specifies the time for adding the correction temperature (SP1915-005) at
recovery from the stand-by mode.
1916 [CPM Down Setting]
Temp.: BW: M
001
Not used
SM
*ENG [0 to 60 / 20 / 1 sec/step]
*ENG [0 to 50 / 20 / 1 deg/step]
*ENG [0 to 60 / 60 / 1 sec/step]
*ENG [0 to 50 / 10 / 1 deg/step]
*ENG [0 to 60 / 60 / 1 sec/step]
*ENG
[100 to 200 / 140 / 1 deg/step]
5-29
Service Mode Table
G133