Ricoh G133 Service Manual page 552

Service Mode Table
013 POP Auth. Encrypt
014 POP Server Port No.
015 IMAP Srv Port No
016 SMPT Rx Port No
017 Receive Interval
019 Mail Keep Sett.
020 Partial Mail Receive Timeout
Sets the amount of time to wait before saving a mail that breaks up during
reception. The received mail is discarded if the remaining portion of the mail is
not received during this prescribed time.
021 MDN Response RFC2298 Compliance
Determines whether RFC2298 compliance is switched on for MDN reply mail.
G133
1: POP3, 2: IMAP4, 3: SMTP
Encrypts or does not encrypt passwords for
POP3/IMAP4 authentications.
[0 to 2 / 0 / 1/step]
0: Automatic, 1: Not encrypt, 2: Encrypt
Specifies the port number of the POP server.
[1 to 65535 / 110 / 1/step]
Specifies the port number of the IMAP4 server.
[1 to 65535 / 143 / 1/step]
Sets the receiving port number for receiving an
e-mail from the SMTP.
[1 to 65535 / 25 / 1 /step]
Specifies the interval for receiving an e-mail.
[2 to 1440 / 3 / 1 min/step]
Sets the mail type kept in the mail server after
receiving an e-mail.
When you set the "1", all e-mails are kept in the
mail server after receiving an e-mail. When you
set the "2", only error mails are kept in the mail
server after receiving an e-mail. When you set the
"0", no e-mail is kept in the mail server after
receiving an e-mail.
[0 to 2 / 0 / 1 /step]
0: No keep, 1: All, 2: Error mail
[1 to 168 / 72 / – ]
[0 to 1 / 1 / – ]
5-230 SM