Ricoh G133 Service Manual page 661

5.4 SD CARD APPLI MOVE
5.4.1 OVERVIEW
The service program "SD Card Appli Move" (SP5-873) lets you to copy application
programs from one SD card to another SD card.
You cannot run application programs from Slot 3. However you can move application
programs from Slot 3 to Slot 2 with the following procedure.
Do not remove the system card from SD card slot 1.
1. Choose an SD card with enough space and put it in SD card slot 2.
2. Enter SP5873 "SD Card Appli Move". Then move the application from the SD Card in
SD card slot 3 to SD card slot 2.
3. Exit the SP mode.
Use caution when you do the SD Card Appli Move procedure:
1. The data necessary for authentication is transferred with the application program from
an SD card to another SD card. Authentication fails if you try to use the SD card after
you copy the application program from one card to another card.
2. Do not use the SD card if it has been used by the user on the computer. Normal
operation is not guaranteed when such an SD card is used.
3. Remove the cover [A] (
4. Keep the SD card in the place [B] after you copy the application program from one card
to another card. This is done for the following reasons:
The SD card can be the only proof that the user is licensed to use the application
program.
You may need to check the SD card and its data to solve a problem in the future.
SM
x 2).
5-339
SD Card Appli Move
G133