Ricoh G133 Service Manual page 546

Service Mode Table
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the
system administrator or key operator.
6. Enter the SP mode and do SP5846 041. After this SP executes
successfully, any user can access the address book.
046 IniSet/All AddrB
Initialize Local Addr
047
Book
Initialize LDAP Addr
049
Book
050 Initialize All Addr Book
051 Backup All Addr Book
052 Restore All Addr Book
053 Clear Backup Info
G133
Clears the information related with UCS.
Clears the local address book information,
including the user code.
Clears the LDAP address book information, except
the user code.
Clears all directory information managed by UCS,
including all user codes.
Uploads all directory information to the SD card.
Downloads all directory information from the SD
card.
Deletes the address book data from the SD card in
the service slot.
Deletes only the files that were uploaded from this
machine.
This feature does not work if the card is
write-protected.
After you do this SP, go out of the SP
mode, and then turn the power off.
Do not remove the SD card until the
Power LED stops flashing.
5-224 SM