Ricoh G133 Service Manual page 620

Service Mode Table
001 A3/DLT
002 B4
003 A4/LT
004 B5
005 A5/HLT
006 B6
007 A6
[Repeat Print Temp.Correction]
9965
These SPs are used for Preventing the fusing temperature overheating due to
a multiple printing job.
JOB Interval: Plain
001 Specifies the job interval time in plain paper mode. The machine does not enter
the temperature correction mode for preventing the overheating for the time
specified with this SP.
JOB Interval: M-Thick
002 Specifies the job interval time in middle thick paper mode. The machine does
not enter the temperature correction mode for preventing the overheating for
the time specified with this SP.
Shift Time
003 Specifies the threshold time for entering the temperature correction mode. If a
job continues for the time specified with this SP, the machine enteres the
temperature correction mode.
Offset Value: Plain: Low
Temp.
004
Specified the offset temperature for the plain paper in the low temperature. The
machine decreases this temperature when a job continues for 600 seconds
G133
*ENG [0 to 960 / 323 / 1 PULSE/step]
*ENG [0 to 960 / 381 / 1 PULSE/step]
*ENG [0 to 960 / 400 / 1 PULSE/step]
*ENG
[0 to 960 / 498 / 1 PULSE/step]
*ENG [0 to 960 / 525 / 1 PULSE/step]
*ENG [0 to 960 / 525 / 1 PULSE/step]
*ENG [0 to 960 / 525 / 1 PULSE/step]
*ENG [0 to 120 / 30 / 1 sec/step]
*ENG [0 to 120 / 30 / 1 sec/step]
*ENG [0 to 1200 / 600 / 10 sec/step]
*ENG [0 to 20 / 5 / 1 deg/step]
5-298 SM