Ricoh G133 Service Manual page 349

1901 [Recovery Temp. Ope. Time]
004 -
1902 [Drum Phase Adj.]
001 Execute
002 Result
003 Auto Execution
1907 [Paper Feed Timing Adj.] DFU
001 Pre-Feed
002 Feed Solenoid ON: Plain
003 Feed Clutch OFF: Plain
004 Feed Clutch ON: Plain
005 Inverter Stop Position
006 Re-Feed Stop Position
007 By-pass Solenoid OFF
008 By-pass Solenoid Re-ON
010 By-pass Feed Clutch ON
012 Feed Solenoid ON: Thick
013 Feed Clutch OFF: Thick
SM
*ENG [0 to 60 / 10 / 1 sec/step] Not used
- Execute drum phase adjustment.
Displays the result of drum phase
adjustment.
*ENG 0: Successfully done
2: Sampling failure
3: Insufficient detection number
Turns the automatic drum phase
*ENG adjustment on or off.
0: Off, 1: On
*ENG [0 or 1 / 0 / - ]
*ENG [–10 to 40 / 0 / 2.5 mm/step]
*ENG [–10 to 10 / 0 / 1 mm/step]
*ENG [–10 to 10 / 0 / 1 mm/step]
*ENG [–10 to 10 / 0 / 1 mm/step]
*ENG
[–10 to 10 / 0 / 1 mm/step]
*ENG
[0 to 40 / 0 / 1 mm/step]
*ENG
[0 or 1 / 1 / - ]
*ENG [–10 to 10 / 0 / 1 mm/step]
*ENG [–10 to 40 / 0 / 2.5 mm/step]
*ENG [–10 to 10 / 0 / 1 mm/step]
5-27
Service Mode Table
G133