Service Mode Table
Adjusts the fixed LD power for each line speed and color.
These SPs are activated only when SP3-041-002 is set to "0".
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Plain: Bk
002 Plain: M
003 Plain: C
004 Plain: Y
005 Thick 1: Bk
006 Thick 1: M
007 Thick 1: C
008 Thick 1: Y
009 Thick 2&FINE: Bk
010 Thick 2&FINE: M
011 Thick 2&FINE: C
012 Thick 2&FINE: Y
[Development DC Bias] Development DC Bias Adjustment
Adjusts the development bias.
Development bias is automatically adjusted during process control; therefore,
adjusting these settings has no effect while Process Control (SP3-041-001
2229
Default: ON) is activated.
After deactivating Process Control with SP3-041-001, the values in these SP
modes are used for printing.
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Plain: Bk
002 Plain: M
G133
*ENG
*ENG
*ENG
*ENG
*ENG
[0 to 200 / 100 / 1%/step]
*ENG
Increasing this value makes the image
*ENG
density darker.
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
[0 to 700 / 550 / 10 –V/step]
*ENG
5-68
SM