Ricoh G133 Service Manual page 443

001 Paper Transfer: 1st Side
[Thick 5: T Edge: Timing]
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge
2697
plate at the paper trailing edge between the erase margin area and the image
area.
001 Paper Transfer: 1st Side
[Thick 5: LL] Thick 5 Paper: LL Environment Coefficient Adjustment
2698
Adjusts the environment coefficient for each mode. When the environment is
detected as LL, SP2691 and SP2692 are multiplied by these SP values.
001 Paper Transfer: 1st Side
002 Separation DC: 1st Side
[Thick 5: ML] Thick 5 Paper: ML Environment Coefficient Adjustment
2699
Adjusts the environment coefficient for each mode When the environment is
detected as ML, SP2691 and SP2692 are multiplied by these SP values.
001 Paper Transfer: 1st Side
002 Separation DC: 1st Side
[Thick 5: MM] Thick 5 Paper: MM Environment Coefficient Adjustment
2700
Adjusts the environment coefficient for each mode. When the environment is
detected as MM, SP2691 and SP2692 are multiplied by these SP values.
001 Paper Transfer: 1st Side
002 Separation DC: 1st Side
2701 [Thick 5: MH] Thick 5 Paper: MH Environment Coefficient Adjustment
SM
*ENG [0 to 400 / 100 / 5%/step]
*ENG
[–100 to 0 / 0 / 1 mm/step]
*ENG [10 to 250 / 80 / 5%/step]
*ENG [10 to 250 / 180 / 5%/step]
*ENG [10 to 250 / 90 / 5%/step]
*ENG
[10 to 250 / 140 / 5%/step]
*ENG [10 to 250 / 100 / 5%/step]
*ENG [10 to 250 / 100 / 5%/step]
5-121
Service Mode Table
G133