Samsung Ubigate iBG3026 Configuration Manual page 91

Configuring Example
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# module ct3 2/0
Router/configure/module/ct3 (2/0)# cable_length 1
Router/configure/module/ct3 (2/0)# framing c_bit
Router/configure/module/ct3 (2/0)# end
Router# show module configuration ct3 2/0
Configuring T1's within CT3
This section shows how to configure T1 channels within CT3 interface.
Configuring Step
Step
1
2
3
4
5
6
7
8
© SAMSUNG Electronics Co., Ltd.
Command
Router# configure terminal
Router/configure# module ct3
[slot/port]
Router/configure/module/ct3([slot/port])
# t1 [T1 number] framing {esf | d4}
Router/configure/module/ct3([slot/port])
# t1 [T1 number] linecode {b8zs | ami}
Router/configure/module/ct3([slot/port])
# t1 [T1 number] yellowalarm {generate
| detect | gen_det | disable}
Router/configure/module/ct3([slot/port])
# t1 [T1 number] circuitId [Circuit ID]
Router/configure/module/ct3([slot/port])
# t1 [T1 number] contactInfo [Contact
Info]
Router/configure/module/ct3([slot/port])
# t1 [T1 number] description
[Description]
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters the terminal
configuration mode.
Enters CT3 configuration mode
Sets a T1 interface and its
framing mode. T1 number
ranges from 1 to 28.
Sets a T1 interface and its
linecode mode
Sets a yellow alarm Configuration
Sets a Circuit ID.
Sets a Contact Information.
Sets an interface description.
55