Configuring Ct3 - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 7. WAN Interfaces
Configuring Example
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# module e1 0/2/0
Router/configure/module/e1 (0/2/0)# circuitId E1234567890
Router/configure/module/e1 (0/2/0)# contactInfo David
Router/configure/module/e1 (0/2/0)# description E1-to-SEOUL
Router/configure/module/e1 (0/2/0)# framing crc
Router/configure/module/e1 (0/2/0)# linecode hdb3
Router/configure/module/e1 (0/2/0)# clock_source line
Router/configure/module/e1 (0/2/0)# end
Router# show module configuration e1 0/2/0

Configuring CT3

The following shows simple steps to configure T3 interface module, WT3-1C.
Configuring CT3 interface
The following steps shows how to configure communication modes for CT3
interface.
Configuring Step
Step
1
2
3
4
5
6
54
Command
Router# configure terminal
Router/configure# module ct3 [slot/port]
Router/configure/module/ct3([slot/port]) #
cable_length {1 | 2}
Router/configure/module/ct3([slot/port]) #
framing {c_bit | m13}
Router/configure/module/t1(slot/subslot/port])#
end
Router# show module configuration ct3
[slot/port]
Purpose
Enters the terminal
configuration mode.
Enters CT3
configuration mode
Sets a cable length
- 1: 0 to 225 feet(default)
- 2: 226 to 450 feet
Sets a framing mode
- c_bit: C_BIT format
(default)
- m13: 226 to 450 feet
Goes back to the
'Router#' prompt.
Shows CT3 module
information.
© SAMSUNG Electronics Co., Ltd.