Snmp Applications Supported; Configuring Snmp - Samsung Ubigate iBG3026 Configuration Manual

SNMP Applications Supported

These SNMP v1 and v2 MIBs can be compiled and used with many popular
SNMP managers including, but not limited to:
HP Openview
MRTG
SNMPvC
NetID
NetCool

Configuring SNMP

This section describes how to configure Simple Network Management
Protocol on an Ubigate iBG3026.
snmp-server community
This command sets the SNMP community name and access privileges.
This entry is a password string that assigns access privileges to SNMP MIBs.
Router/configure/snmp-server# community readuser ro
Router/configure/snmp-server# community writeuser rw
snmp-server target
This command configures the recipient of an SNMP v2 trap.
Router/configure/
snmp-server enable target-traps
This command configures enable or disable to transmit trap groups to a target.
If 'all' type is specified, all traps are sent. The 'snmp-server target' command
should be configured before the 'snmp-server enable target-traps' command.
© SAMSUNG Electronics Co., Ltd.
Ubigate iBG3026 Configuration Guide/Ed.00
snmp-server
# target 90.90.90.240 162 v2c
25