Samsung Ubigate iBG3026 Configuration Manual page 402

CHAPTER 28. SIP Gateway Management
Step
2 voip-gateway
Example)
/configure# voip-gateway
3 host ip-address ip-address
Example)
/configure/voip-gateway# host ip-
address 90.90.90.90
4 exit
Example)
/configure/voip-gateway# exit
Configuring Basic SIP Call Services
This section describes the basic configuration necessary for SIP gateway
functions. Since it is essential for SIP call signaling, it should be done before
other settings. This section describes how to specify the domain name used in
SIP signaling, and the function to enable/disable SIP service.
Prerequisites for Basic SIP Configurations
Before enabling SIP service, a source IP address should be set first using Bind
command or host ip-address command. And, the default domain name to be
used in SIP signaling should already be set using host domain-name command.
How to Configure Default domain name
To specify the default domain name to be used in SIP signaling, follow the
procedure below.
Configuration Steps
configure terminal
−
voip-gateway
−
host domain-name
−
exit
−
360
Command Purpose
Enters voip-gateway configuration
mode.
Sets source ip address for
signaling and media streams.
Exits the current mode
© SAMSUNG Electronics Co., Ltd.
(Continued)