Samsung Ubigate iBG3026 Configuration Manual page 81

Configuring a HSSI PPP Bundle
The following example creates a simple interface bundle utilizing the HSSI
interface with PPP(Layer 2) parameters.
Configuring Step
Step
1
2
3
4
5
6
7
Configuring Example
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# interface bundle wan1
Router/configure/interface/bundle wan1# link hssi 1/0
Router/configure/interface/bundle wan1# encapsulation ppp
Router/configure/interface/bundle wan1# ip address
165.213.89.237 24
Router/configure/interface/bundle wan1# end
Router# show interface bundle wan1
© SAMSUNG Electronics Co., Ltd.
Command
Router# configure terminal
Router/configure# interface bundle
[bundle name]
Router/configure/interface/bundle
[bundle name]# link hssi 1/0
Router/configure/interface/bundle
[bundle name]# encapsulation ppp
Router/configure/interface/bundle
[bundle name]# ip address [IP
address] { [bit mask] | [number of
bits for mask] }
Router/configure/interface/bundle
[bundle name # end
Router# show interface {bundle
[bundle name] | bundles}
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Goes into the terminal
configuration mode.
Sets a bundle interface. 'bundle
name' represents a specific
bundle interface to be configured
at the moment.
Links a HSSI interface to a wan
interface
Selects PPP as an encapsulation
method.
Sets an IP address for the
interface.
Goes back to the 'Router#'
prompt.
Shows configured information of
the bundle interface or all bundle
interfaces.
45