Configuring Rip On A Bundle Interface - Samsung Ubigate iBG3026 Configuration Manual

As in the examples, RIP should be run on the network to be authenticated at
first. The redistribute command is enabled to see to it that the authentication
be performed correctly. Then, the interface to be authenticated, the
authentication mode and string are specified.

Configuring RIP on a bundle interface

Configuring Step
Step
1
2
3
4
5
Configuring Example
The following figure illustrates a simple network configuration.
© SAMSUNG Electronics Co., Ltd.
Command
Router# configure terminal
Router/configure# router rip
Router/configure/router rip# network
[interface]
Router/configure/router rip# end
Router # show ip protocols rip
165.213.89.237
Network
Router/configure/router rip# network 165.213.89.237
or Router/configure/router rip# network ethernet 0/1
Ubigate iBG3026 Configuration Guide/Ed.00
Enters the terminal
configuration mode.
Enters the RIP setup
mode.
Designates a bundle
interface to run RIP on.
Retruns to the 'Router#'
prompt.
Display RIP configuration.
165.213.89.238
165.213.100.0/24
Purpose
101