Configuring Voip Gateway - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 27. VoIP Gateway Management
The common matters regarding Voip Gateway will be discussed in this section,
and the details of working as SIP and H.323 gateway will be described in the
next section,

Configuring VoIP Gateway

Configuring VoIP Bind
This section describes the VoIP bind feature. With this feature, you can specify
the source address of SIP and H323 signaling, and the source address for
media stream as well. You can specify the interface by Bind command or
specify the IP address directly by host ip-address command.
Restrictions for VoIP Bind
The interfaces which you can specify as the source address of VoIP signaling
and media stream via Bind command are ethernet, bundle and loopback.
Prerequisites for VoIP Bind
You must shut down the VoIP service before executing Bind command or host
ip-address command. To execute the Bind command, it is necessary to set IP
address first to the interface to bind.
How to Configure VoIP Bind
1.
setting the IP Address of the interface to be bound
This procedure should be executed first before executing the bind command.
Configuration Steps
−
−
−
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
328
configure terminal
interface
ip address
exit
Command Purpose
Enters global configuration
mode.
© SAMSUNG Electronics Co., Ltd.