Samsung Ubigate iBG3026 Configuration Manual page 85

Step
4
5
6
7
8
9
10
Configuring Example
The following figure illustrates a connection of Ubigate iBG3026 configured
as a DCE.
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# module hssi 1/0
Router/configure/hssi (1/0)# mode dce
Router/configure/hssi (1/0)# clock_source internal
Router/configure/hssi (1/0)# clock_rate 45000000
© SAMSUNG Electronics Co., Ltd.
Command
Router/configure/hssi([slot/port])#
clock_source {internal | line}
Router/configure/hssi([slot/port])#
clock_rate {56,000 to 52,000,000}
Router/configure/hssi([slot/port])#
crc {16 | 32}
Router/configure/hssi([slot/port])#
data_mode {normal | inverted}
Router/configure/hssi([slot/port])#
name {name string}
Router/configure/hssi([slot/port])#
end
Router# show module
configuration hssi [slot/port]
(HSSI DTE)
Router
Ubigate iBG3026 Configuration Guide/Ed.00
Selects a synchronization clock
source. As a DTE, the option,
'internal', is recommended.
Selects a clock rate.
Selects a CRC mode.
Selects a data mode.
Name the interface.
Goes back to the 'Router#' prompt.
Show configured information of the
[slot/plort] HSSI interface.
(HSSI DCE)
HSSI
iBG3026
(Continued)
Purpose
49