Samsung Ubigate iBG3026 Configuration Manual page 82

CHAPTER 6. Serial Interfaces
Configuring a V.35 HDLC Bundle
The following example creates a simple interface bundle utilizing the V.35
serial interface with HDLC(layer two) parameters. Before configuring HDLC
bundle interface, the serial interface is assumed to be configured as a V.35 in
the way described in 'Configuring V.35 as a DCE.'
Configuring Step
Step
1
2
3
4
5
6
7
Configuring Example
The following example shows the commands used to configure the connection
in the figure.
Router# configure terminal
Router/configure# interface bundle wan1
Router/configure/interface/bundle wan1# link serial 1/0
Router/configure/interface/bundle wan1# encapsulation hdlc
Router/configure/interface/bundle wan1# ip address
165.213.89.237 24
Router/configure/interface/bundle wan1# end
Router# show interface bundle wan1
46
Command
Router# configure terminal
Router/configure# interface bundle
[bundle name]
Router/configure/interface/bundle
[bundle name]# link serial 1/0
Router/configure/interface/bundle
[bundle name]# encapsulation hdlc
Router/configure/interface/bundle
[bundle name]# ip address [IP
address] { [bit mask] | [number of
bits for mask] }
Router/configure/interface/bundle
[bundle name]# end
Router# show interface {bundle
[bundle name] | bundles}
Purpose
Goes into the terminal
configuration mode.
Sets a bundle interface. 'bundle
name' represents a specific
bundle interface to be configured
at the moment.
Links a serial interface to a wan
interface
Selects HDLC
as an encapsulation method.
Sets an IP address for the
interface.
Returns to the 'Router#' prompt.
Shows configured information of
the bundle interface or all bundle
interfaces.
© SAMSUNG Electronics Co., Ltd.